Take This to Your Next Staff Meeting
If an external transducer protector becomes wet, does every team member know the next step?
Use our Head Nurse Action Guide to review the CMS response sequence with nurses, technicians, and the staff responsible for machine inspection.
OPEN THE HEAD NURSE ACTION GUIDE →A Wet Transducer Protector Is More Than a Setup Issue
CMS's revised ESRD survey guidance gives dialysis teams a clear response when an external pressure transducer protector becomes wet.
Replace it immediately—and inspect the side that faces the machine.
If fluid is visible on the machine-facing side, qualified personnel should inspect the machine's internal pressure tubing and sensing port after treatment.
Look during treatment. Replace a wet protector immediately. Inspect the machine-facing side. Escalate possible internal contamination.
Change Between Every Patient. Never Reuse.
CMS Appendix H says external arterial and venous pressure transducer protectors should be used for each patient treatment, changed between treatments, and not reused.
If blood or fluid is visible on the machine-facing side, the machine must be opened by qualified personnel after treatment so the internal pressure tubing and sensing port can be checked.
Frequent pressure alarms or repeated adjustments to the drip-chamber level can also be warning signs that deserve attention.
Source: CMS State Operations Manual Appendix H, V120. Always follow the machine and bloodline manufacturers' instructions and your facility's approved policy.
Give the Team One Consistent Response
A small component needs a clear, practiced response when the barrier becomes wet.
|
1
LOOK
Check the protector during treatment for blood or other fluid.
2
REPLACE & INSPECT
Replace a wet protector immediately and inspect the machine-facing side.
3
ESCALATE
If fluid crossed the protector, notify qualified personnel and follow the machine-contamination procedure. |
 |
The Molded Products MPC-85TE transducer protector is designed for in-line use with hemodialysis pressure monitors. Its manufacturer lists a hydrophobic 0.2-micron membrane, standard Luer-lock connections, and sterile, non-pyrogenic construction.
Its job is simple but important: help keep blood and dialyzing fluid from reaching sensitive transducers and internal pressure-monitoring lines while allowing the machine to respond to pressure changes.
The product supports the safety process; it does not replace inspection, escalation, or facility policy.
Confirm compatibility with the specific machine and bloodline before use. Product features are based on current manufacturer information.
Make the Wet-Protector Response Easy to Remember
Share the one-page guide with nurses, technicians, and the qualified staff responsible for machine inspection.
OPEN THE NURSE ACTION GUIDE →Questions? Call Dial Medical. We pick up. 1-800-346-2080
If you no longer wish to receive these emails you may unsubscribe
No comments:
Post a Comment